RD-G10 (10GPH) Gas Unit Specs

RunDry’s RD-G10, 10gph RunDry Evaporators™ are a very efficient alternative for disposing of the wastewater from your industrial facility.This unit can be operate for about $0.08USD/gallon or $0.02USD/liter, this is a significant saving if you are paying for a waste hauler to take your wastewater away!

Model No: RD-G10
Evaporation Rate: 10-11 GPH (38 to 42 L/hr)
Heat Source: Gas or LPG
Power Consumption: 150,000 BTU
Electrical Draw: 120V, 20A
Dimensions (l x w x h): 53″ x 38″ x 44″ (135cm x 97cm x 112cm)
Weight: 1500 lbs. (680 KG)
Heater Controls: Thermostat
Steam Exhaust Fan: Draft Induction, 70CFM
Exhaust Duct Size: 8″ Dia.
Tank Capacity: 85 gal. (321 L)
Construction: Stainless Steel
Heating Chamber: Insulated

Options

  • Auto-fill pump and controls
  • Chloride Resistant Alloy
  • Lift-out Sludge Tray

Download Cost Savings Sheet

Benefits

  • RunDry intentionally for maximum waste disposal
  • Rapid Return On Investment (ROI), click for more on savings
  • Minimal operator interface
  • Multiply layers of safety features
  • No Drain Line Needed
  • Super thick high-temperature insulation makes the sides and top edge cool to the touch

The RD-G10 RunDry Evaporators™ are super for medium size machine shops or food processors that scrub their floors often. Many customers that are looking at our 7gph electric units will actually buy this unit for the cheaper operating cost and for future expansion. Click here for many more applications.

The large evaporation tank holds 85 gallons or 321 liters but even that is not limiting if you get the very popular option to add the autofill feature. These RunDry Evaporators run most efficiently when they are equipped with this autofill option. You accumulate your wastewater in a surge tank and the autofill just keeps topping off the RunDry Evaporator™. It’s your choice if you wish to operate the units in the batch mode or the autofill mode.

The RD-G10 RunDry Evaporators™ has an evaporation rate of 10 gallons per hour or 40 liters per hour. This is based on clean water at ambient temperature. Please note that clean water evaporates at 212°F or 100°C, however as you introduce waste products to your water it can alter the boiling point. It is simple to adjust the operating temperature to accommodate your wastewater, but you should be aware that it may have a slight impact on your evaporation rate.